RC10 long arm conversion.

PLEASE READ BEFORE BUYING.!

The is NOT iconic legal.

The kit was developed to allow the use of wide rear arms on stock hangers at the rear with the JCR transmission case. The geometery is very similar to the original wide arm. This was all designed for using with the JCR rear arm hangers / uprights giving an overall track of 245-247mm approximately. The front end will require the wide front end additional parts as listed below.

Standard shocks will fit fine as do 12mm shown in the picturs, not entire;y sure if 12mm will rub the tyre wall if any wider than a schumacher cactus as shown, although the inner shock pick up could also be used,

Please be aware you may need to do some filing or reaming of holes to get the desired fit you are after.

Kit consists of - 

1) Stiffer than standard wide rear arms - 2pcs

2) stiffer than standard wide front arms with 3 shock mounting points - 2pcs

2) Stainless steel outer arm hinge pins - 2pcs 

3) Longer CVDs +6mm inc hardware - 2pcs

4) 12mm hex to suit the 3/16 rear axle - 2pcs

5) Set of 4 white dished wheels with matching design  - 

Two modern rears with 12mm hex and 2 fronts with 3/8" bearing to suit RC10 axles.

Available in Ivory and black colour.

Other parts needed to complete the wide arm car although you could use it with the standard front end.

1) Longer front and rear upper turnbuckles.

2) RC10T nose plate.

3) RC10T front bulkhead.

4) RC10T front braces.

5) Front shock tower.

6) Longer front shocks,12mm B6 are a good fit.